Reece 32

TAB CUTTING

CLAMPING MATS Inner edges of Clamping Mats must be parallel and equidistant from the sides of the Throat Plate. For thin material the mats should just clear the sides of the Throat Plate. For heavier materi– als, the mats should be set further apart.

E ,.

CLAMPING MAT

THROAT PLATE

To Adjust:

Loosen scre,·1s (E) and set the Mats the required distance Throat Plate.

Clamping fron the

E

CLAM PING MAT

CENTERING OF TAB KNIFE ASSEMBLY Lower ends of Tab [niv~s should be cen– tral+Y located between the Clar.1ping Hats when the Tab Knives are at their top stroke. To Adjust: Loosen screws (F) and -position Tab (A) by removing screw (B). Remove Nut and \lasher (C). To install neu knives, tilt knife up into the Knif c Pointer ( D) and dm-m over the threaded screw; replace wash– er and nut. After sewing - and cutting, a check should be nade to ensure that the Tab Knives are.central to the two rows of stitching; if fine tuninc.is required 1 loo~en nut (C) and adjust set screws (E); tighten nut (C). Knife Assecbly as required. INSTALLING NEH TAB KUIVES ReI!love Knife Holder

~LF_)

POINTER

Back edge of Tab Knife

KNIFE HOLDER '"-____ tAd

ADJUSTING SCREWS

{'E

From the Library of Superior Sewing Machine & Supply LLC